Alemite 3575-D Podręcznik - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik dla Przyrządy pomiarowe Alemite 3575-D. Alemite 3575-D 8 stron. Oil control handle with mechanical meter
Drukuj stronęSER 3575A
Lever And Valve
Removal
1 Using a 2.5 mm Allen key, remove the 2
handle screws (36).
C a u t i o n
Maintain control of swivel. Swivel is un-
der spring tension.
Failure to comply may result in minor or
moderate injury.
2 Remove lever (40).
3 Remove the backup ring (22), O-Ring (23),
then push the valve cam (24) from the han-
dle body (26), and remove O-Ring (25).
Control Handle
Reassembly
1 Clean and inspect all parts. Replace any sus-
pect, worn or damaged components.
Notice
!
Lightly lubricate the valve cam
(24) before assembly.
2 Place O-Ring (23) onto valve cam (24).
Notice
!
Cut out section in middle of
valve cam (24) must face inlet swivel
(33).
Alemite, LLC
3 Replace the valve cam (24) into the body
(26). Note the orientation shown on the as-
sembly drawing. Fit the second O-Ring (25)
and backup ring (22).
4 Slide lever assembly (40) into position and
replace the two Allen screws (36). (Use
thread locker or similar sealant).
5 Replace plunger (28).
Notice
!
End hole in plunger must face
meter.
6 Assemble the valve seal assembly (29), and
spring (30) then replace into the handle
body.
Notice
!
Install spring, small end first.
7 Replace handle sleeve (27).
8 Replace washer (32), O-ring (31) swivel as-
sembly (33) and screw firmly into place
(Use thread locker or similar sealant).
Notice
!
After assembly ensure handle
latch operates correctly.
3
Mechanical Meter Oil Control Handle
Initial Release 10-15