Aerial Ascent 2.0 Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt żeglarski Aerial Ascent 2.0. Aerial Ascent 2.0 7 stron.

steP 1

steP 2

steP 3

With masking tape, cover the area where the mounting brackets

will be placed. This should be done at all points where the tower

will make contact with the deck as well as the surrounding area.

This will help to eliminate scratches to your boat while adjusting and

measuring your tower attachment points.

With your tape measure, measure the distance across the beam of

your boat where the rear mounts will be fixed and write down the

measurement numbers.

Next, measure up from the rear mounts to the front mounting loca-

tions and mark a general location on the masking tape where the

mount will sit.

connect the 2 rear vertical bent tower bars to the top cross bar.

now position the feet the same distance as the measurement you

have from the rear mount beam distance.

Note: Both SIDE and TOP mounts are possible. For a side mount, be

sure to add 1 1/2" to both sides of your tower bar width so a total of

3 additional inches. This is to compensate for the mounting feet.

GUIDE#: BT-ascEnT-001