Abbott RF-POLE Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stojaki i stojaki Abbott RF-POLE. Abbott RF-POLE 16 stron. Generator pole mount
Drukuj stronę
Figure 3. Placing the pole mount on the pole
2.
2.
Slide the pole mount onto the pole until the top of the pole
mount clamp is below the bottom edge of the black pole cap.
NOTE: The top of the pole mount clamp should be at least
1.2 cm below the top of the pole. When installed, ensure the
top of the generator is no higher than 139.7 cm (55 in) from the
floor.
Figure 4. Tightening the cap-head screws
3.
3.
Using the screwdriver included in the kit, tighten the cap-head
screws, alternating between the two, until the pole mount
clamp base is firmly attached to the clamp cap.
Top of pole mount clamp
1.
placed at least 1.2 cm
(0.5 in) below the bottom
edge of the black pole cap
5