Abbra AbbraLink Skrócona instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Panel sterowania Abbra AbbraLink. Abbra AbbraLink 20 stron. Professional series

Installing the Motion Sensor

Activate the battery by removing the

front cover of the sensor, using a

screwdriver. Remove the red tag from the

battery and check that the LED flashes.

Replace the cover and tighten the screw.

Install the Motion Sensor on a solid

interior surface only, between a height of

6' and 8'. Do not aim it at sources of heat,

expose it to drafts, or place it in direct

sunlight.

The Motion Sensor is pre-programmed

with the name LIVING ROOM and has

the HOME & AWAY response type. This

means that as soon as any activity is

sensed when your system is activated in

the AWAY mode, an alert will be

triggered and the siren will sound. In the

HOME mode, the sensor is inactive. You

can change both these settings later if

you desire.

Quick and easy press and stick

mount: You can install Movement

Detectors using the included adhesive

pads, or by screwing it to the wall. Note

that the adhesive tape is very strong.

Simply peel the tape and press on the

device, then press in place at the location

of your choice. The bond will strengthen

over time, and set completely after 72

hours. To attach with screws, you must

open the Motion Sensor and remove the

circuit board by gently flexing the catch at

the top of the board out towards the top

of the housing.

Use the casing to mark drill holes. Insert

the wall plugs and screw the case to the

wall. Replace the circuit board and cover.

Installing the Keychain Remote

Control

The Keychain Remote Control is

supplied with the battery already installed

and is pre-programmed as USER 1.

Press the STAR button. Check that

the Keychain Remote Control LED