Acoustic Energy AELITE Centre Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Głośniki Acoustic Energy AELITE Centre. Acoustic Energy AELITE Centre 4 stron. Acoustic energy aelite centre owner's manual

Drukuj stronę

Check that your amplifier is switched off before installing your

loudspeaker. Failure to do so may result in speaker or amplifier damage.

The diagram illustrates one loudspeaker only.

Conventional

Normal passive wiring requires shorting links to be in place between the

treble/mid and bass sections. The positive (ribbed) cable from the

amplifier positive (or red) terminal should connect with the positive

(red) terminal on the loudspeaker. Similarly the negative (smooth) cable

should connect the amplifier negative terminal (black) to the negative

terminal (black) on the loudspeaker.

Bi-wiring

Bi-wiring separates the bass and treble ground paths in the loudspeaker

and offer sound quality advantages. An extra set of cables is required.

Note that the shorting links are removed between the treble/mid and

bass sections and should be stored for later use if conventional, passive

driving is required.

Two pairs of cables are connected to the amplifier terminals. One cable

of each pair should connect to the treble/mid section and one to the

bass section. The positive (ribbed) cables from the amplifier positive (or

red) terminal should connect with the positive (red) terminals on the

loudspeaker. Similarly the negative (smooth) cables in each pair should

connect the amplifier negative terminal (black) to the negative terminals

(black) on the loudspeaker.

Bi-amping

Bi-amping adds a second amplifier to the system. One power amplifier

drives the treble/mid section of both loudspeakers; a second drives the

bass sections. Note that the shorting links must be removed.

Failure to do so will result in damaging the amplifiers.

As regards the loudspeakers, wiring for bi-amping is achieved in much

the same way as bi-wiring. Treble/mid amplifier positive (red) terminals

should be connected via the ribbed cable to the positive (red) HF

terminal on the speaker. Similarly, treble/mid amplifier negative is

connected to the negative (black) HF terminal on the speaker. Repeat

this process with the bass amplifier and LF terminal pair.

After wiring up

Lower the volume to the

minimum, switch on the

amplifier, select the signal

source and then raise the

volume to the

listening level

required.

REAR OF AELITE CENTRE

Connection

RETAIN LINKS

FOR FUTURE USE

AMPLIFIER

CENTRE