AltRider Hemisphere ALTR-9-4700 Instrukcje instalacji i pielęgnacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcje instalacji i pielęgnacji dla Akcesoria rowerowe AltRider Hemisphere ALTR-9-4700. AltRider Hemisphere ALTR-9-4700 5 stron. Heat shield
2
1
2
//
Hemisphere Heat Shield
Apply the (2) red adhesive foam pads as shown on the back side of the heat
shield.
Open up the stainless steel hose clamp all the way and then feed it through the
two slots of the heat shield with the natural bend of the clamp following that
of the heat shield. Keep in mind that when you tighten the hose clamp it will
naturally pull on the slotted end. If you have a very narrow diameter exhaust,
leave lots of room on the slotted side when feeding the hose clamp into the
heat shield.
Fit up to your bike and tighten the hose clamp with a 8mm socket. You will need
to test fit your luggage to make sure that the luggage is only touching the heat
shield and not some part of the hot exhaust pipe. Try to position the clamp so
that the fastener is hidden behind the exhaust when fully tightened. Adjust as
needed.
If you are installing this heat guard on a DIRT BIKE, or in between the ex-
haust and a fairing, see step #3.
Installation & Care Instructions