Artison Sound Surface 40 Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Głośniki Artison Sound Surface 40. Artison Sound Surface 40 11 stron. Invisible speaker
Drukuj stronę6) Connect Wires
Before installing the speaker into wall or ceiling, the
speaker wire connections must be made. Read the
IMPORTANT items before making connections. Follow
steps below to make these connections:
IMPORTANT: Read items below before making speak-
er connections:
–
Observe polarity when attaching speaker wires.
Connect the positive speaker wire to the side of
connector with the red stripe. Note: The connector
must be removed from speaker to see the stripe.
–
Twist the bare portion of each wire before installing
to ensure no exposed copper strands are sticking
out that could short to other wires.
–
To reduce the chance of wires shorting, no more
/
1
than
inch of bare wire should protrude from the
8
rear of each connection.
–
Do not solder the cable to the connector.
–
Do not tin the strands of the wire with solder.
–
Screw the connector to its mating side on the
speaker. This ensures the connector doesn't unplug
when mounting speaker into wall.
–
Secure the speaker wire to the relief strap. See
Figure 9.
1.
Unplug the phoenix connector from the speaker.
3 /
2. Strip
inch of the jacketing from speaker wires
8
coming out of the wall.
3. Slide wires into connector as shown in Figure 8.
4. Twist each screw on the top of the connector
clockwise (CW) until the silver crimps tighten around
each wire. Tug on wire a bit to verify they are secure.
See Figure 8.
5. Route the speaker wires through the strain relief
strap and tighten strap to secure wires to speaker.
6. Plug the connector back into the speaker. Secure
the connector to the speaker by tightening the
two screws on the front of the connector. Verify
connector is secured to the speaker by pulling on it a
bit to ensure it won't pull out.
7.
With the speaker wires connected, turn the audio
source on and verify the speakers work.
7) Mount Speaker into Wall
1.
With the wire secured to the strain relief strap,
insert all loose wiring into the wall cavity.
2. Grasp the installation handle mounted on the
speaker and insert the speaker into wall. Slide
speaker up into wall until bottom of speaker can be
inserted into cut out hole. See Figure 10.
Surface 40/80 Speakers | 009-1656-01 | 180731
Copyright 2018 Savant Systems, LLC
Installation
Figure 8.
Relief Strap
Figure 9.
Figure 10.
6 of 11
⅜
in
(9.5 mm)
Slide Speaker
Up into Wall
45 Perseverance Way, Hyannis, MA 02601
Savant.com
| 508.683.2500