ARTRED AR50 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Scrubber ARTRED AR50. ARTRED AR50 12 stron.

is suddenly abnormal during use, and the squeegee does not absorb water or

the sound of the squeegee is normal, the squeegee cannot absorb water, you

should stop the operation immediately for inspection;

①The water level has risen to the highest position (floating up cut off the wind

path),you will discharge sewage;

Method: Pull the sewage pipe out of the pipe clip, open the pipe cover, drain

the sewage into the sewer, and wash the sewage tank. (right picture)

② If the water level in the dirty water tank is not high and

there is no excess foam, please check the connection

between the suction hose and the hose, which is likely to

be clogged with debris here, and it will return to norma

after being cleared.

③ If the water level in the dirty water tank is not high, but

there is a lot of foam, this means that it is possible for

your cleaning fluid to add too much or the cleaning fluid

you use is a high foam cleaning liquid.

④ If the above three conditions are not, please pull out the suction pipe on

the suction pickup, open the motor of the suction machine, and use your

hand to try whether the suction of the air intake is normal, if the suction is

too small, check whether the suction connecting pipe is blocked.

Method of Replacing Brush Disk：

Loading brush：Place the brush tray to be placed under the brush cover (if

using the dial, please put the brush on the dial and then put it), and put down

the brush pedal so that the brush head and the brush holder are basically

opposite. At this time, press the control panel to brush the motor start button.

As the motor rotates, the brush disk will be automatically installed. You can

then start the operation or manually install it. For the unskilled staff, it is

recommended to install it manually.

② Unloading brush:After you finish your work, first raise the brush disc, close

the brush disc switch, the motor stops turning the brush disc by hand, and then

the brush disc can be removed.

Battery replacement method:

10.

① Cut off all button switches and open the sewage tank.

②Release the clamp on the battery, remove the battery connection, and

replace the battery separately.

- 10