Alvin PXB36 Instrukcje użytkowania - Strona 2
Przeglądaj online lub pobierz pdf Instrukcje użytkowania dla Narzędzia Alvin PXB36. Alvin PXB36 3 stron. Parallel straightedge board
Również dla Alvin PXB36: Instrukcja obsługi i konserwacji (2 strony)
Drukuj stronę
To Replace or Reset the Wire
Note: A Phillips screwdriver is needed to replace or reset the wire.
Start with the blade centered and locked in the middle of the board.
1
Remove the small Phillips screw from wire capture knob ( I ). (see Figure 4)
2
Loosen wire capture knob enough to thread the wire under the T-bolt ( J ).
3
Thread wire through all four pulleys (see Figure 5) with ends meeting in
4
the middle.
Crosswire should go under the wire cover plate ( K ) in the center of the board.
5
(see Figure 6)
Attach spring to loops at each end of wire ( L ). Spring should be in the center of
6
the board and should ride above the wire cover plate, not under it.
Tighten wire capture knobs and reinsert small Phillips screws. Tighten securely.
7
Care and Handling
Keep top adjustment knobs tight to ensure straightedge stays parallel.
Avoid over tightening adjustment knobs or damage may occur.
Clean board surface and underside of blade with mild detergent and soft cloth. Wipe dry.
When transporting or storing the PXB, lock the straightedge at the bottom edge of the board to minimize the chance of damage.
Protect your PXB from damage by storing and transporting in a protective case.
Do not attempt to move straightedge with brakes tightened.
Avoid direct exposure to sunlight and extreme heat.
Troubleshooting
If straightedge does not slide easily up and down, check that:
Brakes are not dragging
Wires pass properly through pulleys
Pulleys are spinning freely
Spring is not running into pulleys
I
J
Figure 4
Figure 5
K
L
Figure 6
Wire
capture
knob