Akron 8601B Instrukcja serwisowa - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Sprzęt medyczny Akron 8601B. Akron 8601B 14 stron. Childs tilttable
Również dla Akron 8601B: Instrukcja obsługi (20 strony)

Drukuj stronę

General Maintenance

It is recommended that the following checks and adjustments are carried out at

minimum of twice a year and more frequently if the couch is in constant use.

The framework of the couch is of steel construction and coated with an

epoxy paint finish. This is resistant to most cleaning substances.

The major pivot points need to be lubricated sparingly with oil. Care

should be taken to keep oil away from the upholstery.

All nuts should be checked and tightened where necessary. Care

should be taken not to over tighten the nuts on the pivot points as this

may cause them to bind.

Air tubes should be checked to ensure that they are not pinched.

Disconnect the mains supply and check the following;

NOTE - all electrical checks should be carried out by a suitably

qualified person.

Electric cables and mains plug should be inspected for damage and

replaced where necessary. In addition, electrical safety checks for

earth continuity (class I equipment only) and earth leakage checks

should also be carried out.

The correct value fuse of 5 amps and ASTA approved to BS1362

MUST be used.

The upholstered top is manufactured using fire retardant vinyl. This

tends to go brittle if oil or grease (including body oils) are left on it. The

upholstery should be cleaned with warm soapy water after use. The

use of detergents is not recommended although a suitable sterilization

fluid is acceptable. Use of a couch cover or towel will help prolong the

life of the upholstery.

Fixing screws, used to secure the upholstery, should be checked and

tightened or replaced where necessary.

The hinge pins on the head and foot sections should be checked to

ensure that they have not moved within the hinge tubes. If the pin

protrudes, ensure the 'E' clip is located, securing the pin in place. If the

pin moves easily, the 'E' clip may have been dislodged and will need

replacing. Contact Akron Service Dept.

Page 1