Asko ADA Series Instrukcja instalacji - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zmywarka Asko ADA Series. Asko ADA Series 20 stron.

Drukuj stronę

STEP 4. CONNECTING ELECTRICITY, WATER, AND DRAIN

1.
CONNECT DRAIN HOSE
ASKO provides a 7/8˝ (22 mm) diameter corrugated
drain hose which is connected to the back of the
unit to form a high loop.
NOTE:
Do not use any fittings anywhere in the drain
line that are less than 7/8˝ (22 mm) OD.
The access hole for the drain line should be 1-5/8˝ (41
mm)- 2˝ (50mm) max.
The end of the drain line
is 1/2˝ (12 mm), but it
is adjustable to 7/8˝, 3/4˝, 5/8˝ (22mm, 19 mm,
and 16 mm). If the drain connection is larger than
1/2˝ (12 mm), you can easily cut the drain line to fit
the connection.
The illustrations to the right show three ways to
connect the drain supply line.
THE HIGH LOOP
The high loop is necessary for
proper draining. Therefore, all
ASKO dishwashers have the drain
hoses attached to the drain pump
and fastened to the top back of
the unit, as illustrated. This gives the drain hose an
automatic high loop, which is necessary for proper
draining. The drain hose is fastened at the best
high loop height.
To eliminate potential drain problems, simply leave
this hose in place.
DO NOT REMOVE THE HIGH LOOP ATTACHED TO
THE BACK OF THE DISHWASHER!
IMPORTANT THINGS TO REMEMBER:
• Failure to provide the proper drain connection
height (minimum of 20˝ (508 mm) above the
bottom of the dishwasher base) or a 20˝ (508
mm) high loop will result in improper drainage,
which will damage the machine.
• No part of the drain hose should be higher than
35˝ (889 mm) from the bottom of the dishwasher.
• The drain hose can be extended to a maximum
length of 10 feet (3048 mm). Joints and jointed
tubes, if any, must have a minimum 7/8˝ (22
mm) OD.
• If the drain line is going to be connected to a
waste disposer, be sure to remove the knockout
or plug from the fitting on the disposer before
connecting the drain line.
• Do not use fittings smaller than 7/8˝ (22 mm)
OD; otherwise the water may not drain properly.
12
CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM
THREE WAYS TO INSTALL
DRAIN CONNECTIONS
A) Typical connection to sink plumbing before trap
(high loop drain)
B) Connection to air gap then to the trap
C) Connection to waste disposer with air gap
NOTE:
Don't forget to remove the knockout or plug from the
disposer fitting.
24" min.
(610 mm)
20" min.
(508 mm)
24" min.
(610 mm)
20" min.
(508 mm)
24" min.
(610 mm)
20" min.
(508 mm)