Asko D5526XLFI Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Asko D5526XLFI. Asko D5526XLFI 20 stron.
Również dla Asko D5526XLFI: Podręcznik projektowania (20 strony), Podręcznik projektowania (20 strony)

Drukuj stronę

Care and maintenance

instructions

Coarse filter

The coarse filter traps larger food particles, which cannot get

past the drain pump. Empty the coarse filter as necessary.

1 Lift the coarse filter by the handle.

2 Empty the coarse filter. Remember to replace it!

Fine filter

Debris that collects on the fine filter is automatically rinsed away

during each wash. However, the fine filter and its pipe section

should be cleaned a couple of times a year.

1 Turn the handle counterclockwise once.

2 Lift the pipe section straight up by the handle. Free the coarse

filter to clean the pipe section.

3 Remove and clean the fine filter.

4 Replace in reverse order. Check that the edges seal properly

when replacing the fine filter.

5 Lock the filter in place by turning the handle clockwise to the

stop position. The handle should point straight out from the

dishwasher.

Coarse filter

Fine filter

Pipe section

NOTE!

The dishwasher must not be used without the filters in place!

Dishwashing results may be affected if the coarse filter is incor-

rectly fitted.

Drain pump

The pump can be accessed from inside the dishwasher.

1 Cut the power to the dishwasher by unplugging the unit from

the power outlet.

2 Remove the coarse filter and pipe section.

3 Remove the small yellow drain pump access cover at the left

of the bottom drain (see illustration below).

4 By inserting your finger into the hole, you can turn the pump

blades to release anything blocking the pump.

5 Reinstall the access cover and filters.

6 Plug the machine in again.

If the dishwasher still does not start and a whirring sound is

heard, the overflow protection has been triggered.

Shut off the water.

Unplug the unit from the power outlet.

Call the Customer Care Center.

NOTE!

Do not forget to reinstall the drain pump access cover.

Spray arms

Holes and bearings can become blocked. Remove debris using

a needle or similar item. The spray arms have holes on the bottom.

Spray arms can be removed for cleaning. Reinstall after cleaning.