Asko TD70 Instrukcje użytkownika - Strona 15

Przeglądaj online lub pobierz pdf Instrukcje użytkownika dla Suszarka Asko TD70. Asko TD70 16 stron. Tumble dryers

S5 Start/Stop

Start a program by pressing the button and stop by pressing it for 3 seconds.

S6 Time delayed start

The start of a program can be delayed for 1-12 hours. Push the button so many

times that you want the start to be delayed. By thirteenth press, the delay will be

zero. D3 and D4 indicate the chosen amount of hours.

Test program

Through pressing S1.1 5 times and S1.2 for 5 times, you get into a test program.

A press on

There will be a heating up till 50° C . After that the heater, low effect, is turned off.

The heating-up continues to 60°C and then all components are shut off.

During the heating-up the moisture in the machine is indicated by D1 and D2

(normally 3-13). D3 and D4 indicate the temperature.

Fault signals:

The following codes are indicated by D3 and D4.

Overfilling in the condensate water container

Maximal drying time, 3 hours

Thermistor fault

Fluff in the fluff filter or in the condenser (indicated after end of program)

Fault in the moisture sensor

Reasons for faults

Open-circuited or short-circuited thermistor

This will interrupt the program and produce a flashing F3 on the display. An open circuit

can be caused by a broken connection or a faulty thermistor. The resistance of a

helthy thermistor is between 60 kohm and 40 kohm at 20-30°C.

Thermistor not in thermal contact with the fan casing

The heating element will be energised as long as the thermistor does not sense the air

temperature called for by the program, resulting in excessive air temperature.

TD 77

S1.2 will lit

L1-L4 and

S1.3

L5-L8 "

S4 The buzzer is activated

S1.4 starts the motor,heater, high effect, heater low effect, and

outlet pump .

D1-D2

D3-D4