ASL INTERCOM WMC01 Manual de instalação - Página 5

Procurar online ou descarregar pdf Manual de instalação para Controlador ASL INTERCOM WMC01. ASL INTERCOM WMC01 12 páginas. Wall mount controller source select and volume control
Também para ASL INTERCOM WMC01: Manual do utilizador (20 páginas)

Imprimir página
4

Preparation

1.
Read and observe the safety instructions and guidelines in Section "2 Safety and Precautions" (page 3).
Failure to follow these instructions and guidelines may cause personal injury and/or damage to the
product.
2.
Gather the following documentation and tools:
•
The system design documentation of the specific location
•
Suitable cable glands/conduit fixings (Ø 27 mm cable entry hole)
•
A small flat-blade screwdriver and a Phillips screwdriver (M3)
•
Suitable fixings (M4 fixing holes) and tools for wall mounting
•
Sealant
3.
Gather the product (in its original packing).
5

Unpacking and Handling

1.
Observe any markings or warnings on the package prior to handling and opening.
2.
Check the product package for signs of damage during transport. Report problems to the carrier or supplier.
3.
Unpack the product in a dry area handling the equipment with care.
4.
Check the equipment package contents for completeness. Report any missing items immediately.
WMC01 package contents:
•
1 x WMC01
•
4 x M3 black Phillips screws (7.5 mm) (inside the back box)
•
1 x Installation Guide
5.
It is advisable to retain the original equipment packing (containers and materials) in the event that the product
ever needs returning for service.
6.
If the packing is not to be retained, the packing materials should be either recycled or disposed of according to
local regulations.
7.
Ensure that the name and address of the Authorised Distributor from whom you purchased the product is
recorded on the "Service and Warranty" page of this document for future reference.
8.
Repacking instructions are provided in Section "10 Packing for Return" below.
6

Storage and Preservation

This product should be packed for storage in the original packing as described in the Section "10 Packing for Return"
below and stored in the following environmental conditions:
•
Away from harsh environmental conditions, such as areas that are subject to corrosive atmosphere, excessive
moisture or may allow water or other liquids to come into contact with the unit or its external connections.
•
In a heated and humidity controlled storage area where the temperature and humidity are within the equipment
specification.
7

Packing for Return

If a product is being returned for servicing, try to use the containers and materials of the original packaging. Attach a tag
indicating the type of service required, return address, equipment type and full serial number.
If the original packing can no longer be used, the following general instructions should be used for repacking with
commercially available materials:
•
All electronics assemblies must be properly packed in ESD protective packing for transport, to prevent physical and
ESD damage.
•
The filler material used for packing must be antistatic or static dissipative, as this may come into contact with
exposed connectors, wiring, or PCB assemblies. The use of non-conductive filler material may cause damage to the
electronic assemblies reducing their operational life, or even destroying them.
•
Use a sturdy cardboard box that will support the weight and size of the equipment.
•
Attach a tag indicating the type of service required, return address, equipment type and full serial number.
•
Completely wrap the equipment in bubble wrap (all sides must be protected) and secure the wrap in place with tape.
•
Place the wrapped equipment inside the box surrounded by filler material, ensuring that there is no room for
movement.
•
Seal the box securely with packing tape.
WMC01 – Installation Guide
U-0664-0758.docx – Issue: 01 complete, approved
Page 5 of 12