AMD DIrect FPB-25SFPSSF18TPSI-P Manual de instruções de instalação e funcionamento - Página 3
Procurar online ou descarregar pdf Manual de instruções de instalação e funcionamento para Lareira exterior AMD DIrect FPB-25SFPSSF18TPSI-P. AMD DIrect FPB-25SFPSSF18TPSI-P 20 páginas. Square flat pan fire pits with thermocouple piloted safety ignition (tpsi) & pro brass snowflake burner
Imprimir páginaThis product is designed to operate with one of the following fuel sources: Liquid Propane or Natural Gas. The fuel
used to operate this product, and the products of combustion of such fuel, can expose you to chemicals including
Benzene which is known to the State of California to cause cancer, birth defects and other reproductive harm and
Carbon Monoxide which is known to the State of California to cause birth defects or other reproductive harm.
NOTE: An exterior lid/cover is not required but highly recommended when the fire pit is not in use. Even though fire
pits are designed for outdoors they are not impervious to all weather conditions if not protected. See the accessory
page for information and sizes.
Preparation for Non-Combustible Structure
Cross Ventilation Requirements
Installation into an Approved Enclosure
Typical Installation Drawings
Congratulations! You have just purchased a AMD Direct, Inc "Pro Series" Snowflake Burner. These are Brass
Burners that come with a 18" burner. Each model burner incorporates individual injectors that eliminates the
need for a main burner orifice. It uses 24 injectors in each burner.
All media (i.e. lava rock, lava stones, lava boulders and fire glass) has the potential of thermal
spalling. This is a process that may occur when media is wet and moisture gets trapped inside of
the material due to rapid temperature differences. When this happens the media has the potential
WE HIGHLY RECOMMEND COVERING ALL FIRE FEATURES WHEN NOT IN USE
The use of a cover can lessen the impact of thermal spalling; however, heavy rains, high
Extra caution should be taken when lighting a fireplace when heavy rains, high humidity and
moisture are present. Light the fireplace; leave the area allowing any moisture in the media to
dissipate. We strongly recommend that during this drying out time that you monitor the fire feature
from a distance. This drying out period should be no less than 30 minutes. Continue monitoring
the flame from distance to ensure that all popping has ceased before fully enjoying the fire.
Drop In & Flat Pan Fire Pits with Snowflake Burner and (TPSI) Ignition
CALIFORNIA PROPOSITION 65
(For more information go to: www.p65Warnings.ca.gov.)
TABLE OF CONTENTS
to crack or "pop" outside the fireplace.
humidity and the presence of moisture may still cause the media to pop.
ALWAYS USE CAUTION WHEN USING THE FIRE FEATURE
WARNING
4
5
5
6
6
6
7
8
9
8-9
10
10
11
12
13
14
REV. A
Page 3