AmeriGlide RUBEX Manual de instalação - Página 7
Procurar online ou descarregar pdf Manual de instalação para Sistemas de elevação AmeriGlide RUBEX. AmeriGlide RUBEX 16 páginas.
Também para AmeriGlide RUBEX: Manual do Proprietário (8 páginas)
Imprimir página11819 P/N: 16169 Rev D
Step 5: Use the track bracket bolts to fasten brackets to
nuts in the track channel.
Position track brackets as follows:
a) 1 bracket pair on bottom step
b) 1 bracket pair on top step
c) 1 bracket pair above and below where the tracks
splice together
Hand tighten the bolts only - the brackets will need to
slide for correct positioning.
Step 6: Splice bars are used to join the track sections
together. Locate the splice bars and loosen the set screw
from their shipping position. Slide the spice bars to half
way and tighten the two set screws remaining in the track
to hold them in place. The tracks will not slide together if
the set screws protrude beyond the splice bar.
Allen Wrench
Step 7: Slide the upper track section onto the
lower track section. Tighten the splice bar set
screws to lock tracks together.
Caution:
Do not put your fingers between the track
sections at any time as injury could occur.
detail of track section showing position of splice bars
Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648
do not remove
foam packaging
Note
Attach a bracket on the bottom
nut, but leave the nut second
from the bottom unused - it will
be used later.
Allen Wrench
7 //
16