Astrel Instruments AST-8300-A Começar a trabalhar - Página 13

Procurar online ou descarregar pdf Começar a trabalhar para Câmara de segurança Astrel Instruments AST-8300-A. Astrel Instruments AST-8300-A 20 páginas.
Também para Astrel Instruments AST-8300-A: Manual do Automanualr (14 páginas), Manual do utilizador (6 páginas)

Astrel Instruments
Tutorial: from power up to the first photo
This tutorial will guide you in the process of making your first photo with the AST8300 camera.
We will use Windows in Connected mode: most of the steps are the same also with Linux in
Connected mode, while many steps are not needed in Stand Alone mode.
STEP 1: evacuate the camera
• Screw the pump connection tube to the valve on the camera
• Insert the vacuum pump on the other side of the tube
• Start pumping the air: if the vacuum level keeps going back to 0, push the pump nose as
much as possible inside the tube and screw the tube as much as possible inside the
valve, until the vacuum is retained: this means that the pump is correctly connected to
the camera
• Open the vacuum valve (the handle should be perpendicular to the camera back)
• Pump the air until a level of 25 inHg vacuum is reached
• Close the valve
• Rotate the knob near the nose of the pump to release the vacuum remained inside the
connecting tube, disconnect the pump and remove the tube
• The camera is now ready for being cooled below freezing temperature and the vacuum
should be retained to an acceptable level for at least 2 days
• You can check the vacuum level connecting the pump to the camera, pumping the air
until a level of 25.5 inHg vacuum is reached with the vacuum valve closed to remove the
air inside the connecting tube, and then opening the vacuum valve and reading the
vacuum level.
STEP 2: power up the camera
Stand Alone mode:
• Mount the touch LCD monitor and plug the flat cable to the LCD connector
• If needed plug any USB device and hub to the USB ports
• Plug the power supply
Connected mode:
• Plug the wifi USB adapter or connect the Ethernet cable to the camera and the PC
• If needed plug any USB device and hub to the USB ports
• Plug the power supply
Getting Started
Remember to close the valve before disconnecting the pump
13/20
AST-8300-A
rev D