Akw 2842246 Manual de instruções de instalação - Página 6

Procurar online ou descarregar pdf Manual de instruções de instalação para Produto de canalização Akw 2842246. Akw 2842246 8 páginas. Shower tray

Imprimir página

Solid Floor Installation

Position the tray over the desired

location for the shower and outlet

pipe. Mark around the edge of the

shower tray and the waste area.

For 'in' floor or 'on' floor

installation remove the floor

material for the waste area and

a channel for the outlet pipe.

Lower the tray into position and

check the height compared to

the finished floor height. Firmly

secure the tray into position and

check all 4 sides are level again.

For 'in' floor installation, cut into

the flooring, taking care not to

cut through any supporting

material, plumbing or electrical

wiring.

Install the waste drain trap and

waste outlet pipe. Water test the

waste for flow and for any leaks.

Ensure that the rubber seal is in

place on top of the trap. Check the

waste drain position with the tray.

Attach the waste trap to the tray

with the waste clamping ring,

see separate waste instructions.

Apply a waterproof membrane to

the whole of the showering area,

see manufacturers instructions.

Carefully remove the flooring to

suit the finished height of the

tray and final floor covering. For

'on' floor installation, remove the

material around the waste area.

Remove any debris and ensure

that there are no sharp edges or

raised areas that will affect the

tray height. Add 6:1 cement mix to

the full tray area and correct height

including all supporting edges.

Safety flooring or tiles should

finish flush up to the edges of

the tray and sealed with sealant.

Protect the waste trap and cover

from debris during installation.

General: 01905 823 298