Akw Arka Thermostatic Cool Touch TMV2 Manual de instruções de instalação - Página 4

Procurar online ou descarregar pdf Manual de instruções de instalação para Produto de canalização Akw Arka Thermostatic Cool Touch TMV2. Akw Arka Thermostatic Cool Touch TMV2 12 páginas. Mixer shower

Imprimir página

installation

Installing the Fast Fit Kit

1. identify all components are present prior to

starting installation.

2. mark the position for the pipework and the

fixings supplied.

note: the pipe centres required for this

thermostatic mixing valve are 150 mm.

Before drilling into walls, check that there are

no hidden electrical wires, cables, or water

supply pipes. this can be done with the aid

of an electronic detector.

3. Drill suitable holes in the wall surface at the

marked positions to accommodate the supply

pipework and fixings.

4. terminate the pipework in the wall, ensuring

that there is at least 30 mm of 15 mm diameter

pipework protruding from the finished wall surface.

Important

match up the water supply pipes with the

thermostatic mixer valve. the must be with the hot

on the left and the cold on the right when viewed from

the front.

5. place the inlet cover (1) over the supply pipe.

Use the wall plugs (2) and screws (3) provided

to fix the wall plates to the wall.

6. place the olive (4) onto the protruding

pipework. impoRtant: the pipework must not

protrude past the olive (4) by more than 5 mm.

7. Screw 1/2" - 3/4" BSP fitting (5) onto the wall

plate (1) using a 24 mm spanner. Repeat this

step on the other side.

8. Screw the covers (6) over the wall plates /

1/2" - 3/4" BSP fittings (5) so that they are flush

against the finished wall surface.

150 mm Centres

General: 01905 823 298

30 mm