Canon LV-8300 Manual do utilizador - Página 21
Procurar online ou descarregar pdf Manual do utilizador para Software Canon LV-8300. Canon LV-8300 25 páginas. Lv-series multimedia projectors
Também para Canon LV-8300: Manual do produto (18 páginas), Manual de iniciação (6 páginas), Brochura e especificações (4 páginas)
Imprimir página
2.5.7
Setting the Protocol of a Projector
Projectors in the Projector list will display as "Disconnected" if network settings of projectors
are changed. In this case, adjust the protocol settings of the projector labelled "disconnected"
in accordance with the changed network settings, with the following procedures.
1
Select [Protocol settings] from the [Projector] menu.
"Protocol settings" dialog will appear.
2
Select a protocol from the [Protocol] pop-up menu, and adjust the settings.
Category
IP address
Community name
(SNMP V1/V2c/V3 only)
Port number
(LV Series only)
Timeout
Password
(SNMP V3 only)
Note
-
An error message will appear and settings will not be registered if a value
of an entry is invalid or insufficient. Correct it as required.
-
Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
clicking the [OK] button.
-
Projectors may not connect immediately after its IP address is changed.
Refresh the projector status after a while.
3
Click [OK] when you have finished adjusting the settings.
Projector's protocol settings will be changed.
Enter an IP address of the projector, in "XXX.XXX.XXX.
XXX" form.
E n t e r a c o m m u n i t y n a m e w i t h i n 1 5 o n e - b y t e
alphanumerical characters and symbols.
Enter a port number to be used, in one-byte numbers.
Default value is set to "7142".
Enter a number of seconds to time out, from 1 to 9.
Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
* Password is reset if protocol is changed.
CHAPTER 2 • Routine Operation
Description
2C