Asus AP5000 Manual de instalação - Página 22

Procurar online ou descarregar pdf Manual de instalação para Servidor Asus AP5000. Asus AP5000 32 páginas. Dual pentium ii server platform

III. Integration Procedures

NON SAF-TE back plane boards

To install a slot card for a non SAF-TE back plane board, three cables connect to slot

card shown below, one (SCSI_ID) for SCSI device and the other two (KEY and

PLED) for drive bay. And for the two unconnected cables; SLED and ALED_IN

cables, they should be connected together, so that the SCSI device access status will

present to Light-2 (STATUS LED) of drive bay directly without going through the

slot card, because there is no function for this two jumper on slot card if the Back

Plane Board is non SAF -TE.

KEY

Jumpers for Drive Bay

CAUTION

* PLED cable, 3-wire (Orange/Black/

Green), connects Green to position #1 of

PLED jumper.

* KEY cable, 2-wire (Black/Red) connects

Black to position #1 of KEY jumper.

Fig 3-21: Jumper Location & Cabling with non SAF-TE Features

SLED

PLED

1 1

Jumpers for SCSI Drive

ASUS AP5000 Installation Guide

ALED_IN

SCSI_ID

SLED and ALED_IN

cables link together in

between by this jumper. The

direction should be Green

wire of SLED cable to Red

wire of ALED-IN cable.

* SCSI_ID cable, 8-wire, connects between

SCSI_ID jumper of slot card and ID

jumper of SCSI drive. Be sure their SCSI

ID matched