Bosch DISHWASHER Manual de Instruções - Página 25

Imprimir página

Installation

The required installation dimensions can

be found in the installation instructions.

Level the appliance with the aid of the

height-adjustable feet. Ensure that the

appliance is situated securely on the floor.

– A built-under or integrated appliance

which is installed subsequently as a

free-standing appliance must be

secured to prevent it from overturning,

e.g. by screwing it to the wall or by

installing it under a continuous worktop

which is screwed to adjacent

cupboards.

– The appliance can easily be

installed in a fitted kitchen between

wooden and plastic walls.

Waste-water connection

– The required work sequence can be

found in the installation instructions. If

required, fit a siphon with an drainage

connection.

– Connect the waste-water hose to the

drainage connection of the siphon with

the enclosed parts.

Ensure that the drainage hose is not

kinked, crushed or twisted and that

there is no cover plate in the drainage

to prevent the waste water from flowing

out!

Fresh water connection

– Connect the fresh-water connection to

the tap according to the installation

instructions with the enclosed parts.

Ensure that the fresh-water connection

is not kinked, crushed or twisted.

– When replacing the appliance, always

use a new water supply hose.

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing valve

ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

cold water preferred; hot water max.

temperature 60 °C.

Warm water connection *

Wa r m w a t e r c o n n e c t io n

* depending on model

The dishwasher can be connected to cold

or hot water up to max. 60 °C.

Connection to hot water is recommended

if the hot water can be supplied

by energetically favourable means

and from a suitable installation, e.g. solar

heating system with circulation line.

This will save energy and time.

The hot water setting :

to adjust your appliance optimally

to operation with hot water.

It is recommended to have a water

temperature (temperature of the incoming

water) of at least 40 °C and no more than

60 °C.

It is not recommended to connect

the appliance to hot water if the water

is supplied from an electric boiler.

Setting hot water:

– Close the door.

– Switch on ON/OFF switch (.

– Hold down programme button # and

press START button h until : ... is

indicated on the digital display.

– Release both buttons.

The LED for button # flashes and the

digital display )* displays the factory

setting :

– Press programme button # until the

factory set value :

the digital display )*.

To change the setting:

– By pressing the 3 button, you can

switch the hot water setting off :

– Press START button h.

The set value is saved.

allows you

is indicated on