Advanced Control HomePro ZDW103 Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Automatização doméstica Advanced Control HomePro ZDW103. Advanced Control HomePro ZDW103 7 páginas. Wall mounted 3-way dimmer receiver

Imprimir página

Group 4

Only associate transmitters or controllers into Group 4. Group 4 should be used only to update a transmitter or

controller on the status of the ZDW103 which might have been controlled from another device.

You can associate up to 5 Z-Wave devices into each of these four groups. For instructions on how to "associate"

a Z-Wave device into one of these groups, refer to your wireless controller instructions. (If you are using the

ZTH100 controller, refer to the Setup Menu, Association section).

A note about dimming, if you combine Z-Wave enabled dimmers and other types of Z-Wave devices in a group,

place a Z-Wave enabled dimmer into the empty group 1

Configuration

The ZDW103 supports the Configuration command.

The ZDW103 can be configured to operate slightly differently than how it works when you first install it. Using the

Configuration command you can configure the following:

You can use a ZTH100 to send Configuration commands. (Refer to the Setup Menu, Configuration section)

Set Ignore Start Level Bit When Transmitting Dim Commands

• Parameter No: 1

• Length: 1 Byte

• Valid Values = 0 or 1 (default 1)

The ZDW103 can send Dim commands to Z-Wave enabled dimmers. The Dim command has a start level

embedded in it. A dimmer receiving this command will start dimming from that start level if this bit is set to 0. If

the bit is set to 1, the dimmer will ignore the start level and instead start dimming from its current level.

Suspend Group 4

• Parameter No: 2

• Length: 1 Byte

• Valid Values = 0 or 1 (default 0)

You may wish to disable transmitting commands to Z-Wave devices that are in Group 4 without "un-associating"

those devices from the group. Setting parameter 2 to the value of 1 will stop the ZDW103 from transmitting to

devices that are "associated" into Group 4.

It is possible that you may only want the units in Group 4 to track when the dimmer is being turned ON and OFF

and not when dimming.

Disable Group 4 During a Dim Command

•

Parameter 13

•

Length: 1 Byte

•

Valid Values = 0 or 1 (default 0)

After the ZDW103 is commanded to stop dimming, it will then command the Z-Wave devices in Group 4 to the

ZDW103's new level. To prevent the ZDW103 from commanding the Z-Wave devices in Group 4 during this

particular occurrence, set Parameter 13 to the value of 1.

Night Light

• Parameter No: 3

• Length: 1 Byte

• Valid Values = 0 or 1 (default 0)

The LED on the ZDW103 will by default, turn ON when the load attached is turned ON. To make the LED turn ON

when the load attached is turned OFF instead, set parameter 3 to a value of 1.

Invert Switch

• Parameter No: 4

• Length: 1 Byte

• Valid Values = 0 or 1 (default 0)

To change the top of the switch to OFF and the bottom of the switch to ON, set parameter 4 to 1.

ZDW103 Instructions, Release 1.1

P/D 102406

to ensure that the dimming operates correctly.

0703-01

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC.