Drazice PTO 1733 Manual de operação e instalação - Página 8

Procurar online ou descarregar pdf Manual de operação e instalação para Aquecedor Drazice PTO 1733. Drazice PTO 1733 14 páginas. Little flow heaters

Close the main water inflow. Screw a low-pressure combination faucet with a decorative rosette on the

water inlet neck G 1/2". Seal the threads on the water inlet. Insert sealing rings into the outlet terminals

of the faucet. Loosen 2 screws fastening the cover on the sides of the flow heater so that the thrust

bottoms in the holes on the rear side created a space for sliding in the attached holder. Mount on the

holder. Mount the flow heater preliminary on the combination faucet and evenly tighten the alligator nuts

using wrench No 16. Mark holes for wall plugs on the side. Disconnect the flow heater from the faucet.

Bore the marked holes on the wall with a 8 mm drill bit into the depth of 40 mm. Place the wall plugs

into the hole and fix the holder with two spiral dives. Insert a sieve into the flow heater cold water inlet

marked with an arrow, unless this has already been done by the manufacturer. Put the heater on the

fastened holder and tighten the 2 screws on the sides of the flow heater. Connect the combination faucet

by even tightening of the alligator nuts. Before opening the main water closure, unscrew the pearlator

on the drain arm or the shower saver.

First open the cold water valve on the combination faucet to let contaminated water flow

out. Open the hot water valve and bleed the flow heater.

Mount the pearlator on the drain arm only when clean and bled water flows out. After that, the appliance

can be connected to power supply.

2.1.2 LOW INSTALLATION

Close the main water inflow. Fasten the combination faucet under the hand basin or the sink. Connect

the cold water pipe (hose) of the combination faucet to the corner valve of cold water inlet. The corner valve

outlet must have thread 3/8". Mount the flow heater on the wall in the same manner like for the elevated

installation. The inlet and outlet of the heater must be directed upwards. When fixing the heater make

sure the distance for connecting the inlet and outlet pipe (hose) of the combination faucet is sufficient.

Connect the cold water inlet and outlet pipe (hose) of the combination faucet to the heater as indicated

by colour arrows. Before tightening the alligator nuts insert a sieve in the cold water supply pipe - unless

the manufacturer has already done so. Open the main water lock.

Figure 3

- 8 -