Alen MDF1-30AE Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Desumidificador Alen MDF1-30AE. Alen MDF1-30AE 12 páginas. Alen dehumidifier owner's manual

Imprimir página

CONTROL PADS ON THE DEHUMIDIFIER

Power on

indicator light

Power

1 1

Control pads

1 1

POWER Pad

Press to turn the dehumidifier on and off.

2 2

Continue Pad

Select for the dehumidifier to operate

continuously for maximum dehumidification

until the bucket is full. The Humdity set

control pads cannot be used when

Continuous operation is on.

3 3

Humidity Set Control Pads

The humidity level can be set within a

range of 35%RH(Relative Humidity) to

80%RH(Relative Humidity) in 5%

increments.

For drier air, press the

to a lower percent value(%).

For damper air, press the

set a higher percent value(%).

Other features

Bucket Full Light

Glows when the bucket is ready to be

emptied, or when the bucket is removed

or not replaced in the proper position.

Auto Shut Off

The water level control switch shuts off the

dehumidifier when the bucket is full, or when

the bucket is removed or not replaced in the

proper position. When the setting humidity

is reached, the unit will be shut off automatically.

Continuous

Bucket full

operation on

indicator light

5 5

Continuous

Full

Humidity%

2 2

3 3

pad and set

pad and

High fan

Normal fan

indicator

indicator light

light

Normal

Turbo

4 4

Fan speed Pads

Control the fan speed. Press to select either High or Normal

fan speed. Set the fan control to High for maximum moisture

removal. When the humidity has been reduced and quiet

operation is preferred, set the fan control to Normal.

5 5

Display

Shows the set % humidity level while setting, then shows

the actual(+5% accuracy) room % humidity level.

Error Codes:

E1- Humidity sensor error--Unplug the unit and plug it back

in. If error repeats, call for service.

E2- Temperature sensor error-- Unplug the unit and plug it

back in. If error repeats, call for service.

P1- Unit is defrosting-- Allow the unit time to automatically

defrost. The error will clear after the unit self defrosts.

P2- Bucket is full-- Empty the bucket and replace in

the right position.

Auto Defrost

When frost builds up on the evaporator coils, the

compressor will cycle off and the fan will continue to

run until the frost disappears.

Power Outage

In the case of a power outage or interruption, the unit will

automatically re-start, in the settings last used, after the

power is restored.

Fig.1