Andersen VeriLock Manual - Página 4

Procurar online ou descarregar pdf Manual para Sensores de segurança Andersen VeriLock. Andersen VeriLock 6 páginas. Security sensor lock
Também para Andersen VeriLock: Manual (13 páginas), Manual (6 páginas), Aplicação (10 páginas), Aplicação (6 páginas), Manual (6 páginas), Manual (5 páginas), Manual de serviço (6 páginas)

Imprimir página
4
Sensor contains an anti-tamper switch. Do not apply sensor over wet
finish or rough/dirty surface. Improper switch function may result.
Interior
El sensor contiene un interruptor de seguridad. No instale el sensor en
acabados húmedos o superficies sucias/ásperas. Esto podría dar como
resultado un mal funcionamiento del interruptor.
VeriLock Sensor
(anti-tamper switch)
Sensor VeriLock
(interruptor de
seguridad)
(back view)
(vista trasera)
Verify panel surface is clean and dry. Position latch lever and VeriLock sensor assembly on panel as shown and fasten using #10 x 2" screws
included. The indicator light will illuminate for one (1) second when the sensor assembly is applied to the panel as the anti-tamper switch is
depressed.
Verify panel surface is clean and dry. Position latch lever and VeriLock sensor assembly on panel as shown and fasten using #10 x 2" screws
included. The indicator light will illuminate for one (1) second when the sensor assembly is applied to the panel as the anti-tamper switch is
depressed.
Magnets are small parts and, if swallowed, could pose a choking hazard to young children.
Los imanes son partes pequeñas que, en caso de ingesta, pueden representar un riesgo de asfixia para niños pequeños.
5
Do not pinch or drill through weatherstrip. Product
damage will occur.
Interior
Do not pinch or drill through weatherstrip. Product
damage will occur.
Position magnet on side jamb behind weatherstrip. Slide tight to interior edge of lock receiver as shown and pre-drill two (2) 1/8" holes, 3/4"
deep using magnet holes as a template. Fasten with two (2) #6 x 1" screws.
Position magnet on side jamb behind weatherstrip. Slide tight to interior edge of lock receiver as shown and pre-drill two (2) 1/8" holes, 3/4"
deep using magnet holes as a template. Fasten with two (2) #6 x 1" screws.
9136270
(front view)
(vista frontal)
Magnet Application/
Magnet /
Imán
Side Jamb
Interior Side
Jamba lateral
Lado interior
Weatherstrip
Lock Receiver
Burlete
Receptor del cerrojo
Indicator
Light
Luz
indicadora
Aplicación del imán
Side jamb and weatherstrip shown transparent for clarity.
La jamba lateral y el burlete se muestran transparentes para
que haya claridad.
1/8" Drill Bit
Broca para taladro
de 1/8"
4
Latch Lever
(unlocked position)
Palanca del pestillo
(en posición de
desbloqueo)
#10 x 2" Screws
(included)
#10 x 2" Screws
(included)
#6 x 1" Screw
Tornillo n.° 6 x 1"
Phillips Screwdriver
Destornillador Phillips