Dreamline ENIGMA SHDR-60727912 Series Manual de instruções de instalação - Página 15

Procurar online ou descarregar pdf Manual de instruções de instalação para Produto de canalização Dreamline ENIGMA SHDR-60727912 Series. Dreamline ENIGMA SHDR-60727912 Series 17 páginas. Shower door

Imprimir página

Enigma Roller adjustment procedure for Enigma and Enigma-X

To achieve minimal clearance beneath the door glass without making contact with the

bottom guide block and creating a good seal with the wall.

Have at least two 1/4" shims or wedge shims (to maintain space beneath the door glass) and an

assistant available to help with this procedure.

You should adjust only one wheel at a time and you may need to perform these steps more than once

to get the desired results.

Caution: The door glass is heavy and may require two people to safely accomplish these steps.

1. First, loosen and lower either the Roller Guards (Enigma-X) or Bottom Rollers (Enigma) to

allow you enough room to adjust the upper rollers. (If you have not installed these yet, you will be

instructed to do so in step #7 after these adjustments have been made).

2. Loosen the set screw on the roller. (See note 2 below)

3. Loosen the big bolt just enough so that you can rotate the adjustment disk. (See note 3 below)

4. Rotate the adjustment disk to raise or lower the door slightly with help from an assistant. You can

use a small tool (like an allen wrench) to aid in turning this disk by inserting it into the small hole on

the edge of the adjustment disk. (see note 4 & 4a below)

5. While holding the adjustment disk in place, retighten the big bolt. Use a shim or have an assistant

hold the door glass in place while you retighten the big bolt.

6. Retighten the set screw to hold the big bolt in place and test the operation of the door.

7. For the Enigma-X: reposition the roller guards approx. 1/16" shy of touching the guide rail and

retighten.

For the Enigma: adjust the lower rollers to make contact with the rail in the same manner as the

upper rollers.

Loosen this set screw first.

This holds the big bolt in

place and will need to be

re-tightened after roller is

adjusted.

"Enigma" Ver.4 Rev.5 02/2016

The bushing that goes through

the glass is elliptical and allows

you to raise or lower the glass

when you rotate the adjustment

disk.

Once you have loosened

the set screw, you will be

able to loosen this big bolt

just enough to allow you

to rotate the adjustment

disk.

This is the adjustment

disk. Once the big bolt is

loosened, rotate this disk

to raise or lower the door

glass slightly. Use caution

so that the door glass does

not make contact with the

guide block.

Insert a small tool (like an

allen wrench) into this hole to

help rotate this adjustment

disk and also to hold the disk

in place when you retighten

the big bolt.