AirTech 70-112B Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Rádio AirTech 70-112B. AirTech 70-112B 6 páginas. Land mobile radio (lmr)

Imprimir página

Operation

1. Power Turn on / off and Volume Control

Rotate the Power on/off and Volume Control Switch∠

clockwise to turn power on, then the LED√ lights orange

and power–up tone is generated after about on second,

indicating the transceiver has passed the self–diagnostic.

When you turn on the transceiver, it comes same

channel and function with your last using. Rotate this

switch∠

clockwise

counterclockwise to reduce the volume. Rotate it∠

counterclockwise fully to turn power off.

2. Channel Selecting

Rotate the Channel Select knob as you desire a channel

number.

3. Transmit

Hold down the PTT Button¬ and talk to MIC in 5~7Cm

distance. The LED lights red on transmitting. Release

the PTT button¬ to stop transmitting.

4. Receive

Choose the channel by pressing Channel Select Button∇

as you desire. The LED lights green on receiving. In

case the signal doesn't match in using sub–tone, green

light blinks.

5. Monitor

Press the Monitor Button∨ to monitor. Holding down

Monitor Button∨ over 2 seconds keeps monitoring

function on, and press Monitor Button∨ shortly or press

PTT Button¬ to stop.

6. Scan

1). Scan will be started by press and hold the function

button more than 1 second.

increase

the

volume

In case Priority Scan not settled down

1) mem 1ch > mem 2ch > mem 3ch > .....

In case 1 cannel of Priority Scan is settled down

2) mem 1ch > pri ch > mem 2ch > pri ch > .....

In case 2 cannels of Priority Scan are settled down

3) mem 1ch > pri 1ch > pri 2ch > mem 2ch > .....

2). Tx channel of scanning

a). Priority type : priority channel(the channel that is set

by the channel selector)

b). Non priority type : last busy channel

3). While in scanning mode, function button is pressed 2

times rapidly the radio will return to the last busy channel

The priority channel remained the channel that is

indicated by channel selector.

4). While the radio is stopped scanning on a busy

channel, pressing the monitor button will cause scan to

resume and temporarily bypass the busy channel. If the

channel become busy again scan will stop.

5). While the radio is stopped scanning on a busy

channel, press and hold the monitor button more than 1

second will cause this channel to be deleted from scan

list until scan list is reset.

7. Selcall function : will be added....

5 7