Atlas Copco 8433327030 Instruções do produto - Página 9
Procurar online ou descarregar pdf Instruções do produto para Ferramenta eléctrica Atlas Copco 8433327030. Atlas Copco 8433327030 20 páginas. Battery-powered nutrunner
Imprimir página
ETP SRB 31-20-10
Installation
Installation Requirements
Installation
For installation guideline, see Power Focus 6000 Configuration manual.
Installation Instructions
Torque Adjustment
For installation of the torque adjustment, see Power Focus 6000 Configuration manual.
The torque adjustment factor is stored in non-volatile memory in the tool. Any changes made to the
torque adjustment factor in the POWER FOCUS 6000 will update the stored value in the tool.
Rapid Backup Unit
The Rapid Backup Unit (RBU) has the form factor of an SD card. The RBU contains all the current net-
work configurations and settings. During the installation and configuration some of the parameters are
saved on the card. In case of a failure, it is a quick task to remove the card and put it into a new tool and
all functionality remains the same.
When the RBU is transferred from one tool to another, the new tool will be updated to the software on
the card. Since there is a chance of loss of data during the update procedure, it is good practice to
make sure the new tool is already running the same software version as the old tool, to minimize the
risk of data loss.
This RBU can not be used for anything but storing the tool configuration data and software. Reformat-
ting the card, as well as manipulating the data on the card through other means than ToolsTalk Ser-
vice 2, will result in an unusable card.
Note that the saved results associated with the tool will be lost when the RBU is transferred to an-
other tool.
The MAC-address is associated with the RBU, not with the tool itself. When transferring a card to a
new tool, the tool's MAC-address will therefore be the RBU's MAC-address.
Tool Conversion
When converting a tool (for example, by changing the front part), you are required to update the tool infor-
mation in order to reflect the changes made to the tool. For more information see ToolsTalk Service 2
User Edition user guide
WARNING Risk of injury
Tool modifications, when not done properly, can cause bodily injury, damage to the tool, or produce
undesired results, due to the altered characteristics of the tool.
Check the tool's max torque after modification
►
When connected to ToolsTalk Service 2 you will not be prompted to change the tool information. To
change the tool designation to match the tool conversion, perform the same steps as those for spare part
replacements. Use the tool designation of the new part to update the tool.
Since the tool has been converted, the tool information stored on the tool will no longer match the tool
designation on the tool sign.
EN
© Atlas Copco Industrial Technique AB - 9839 0852 01
Installation
9