Alert 550R LCD Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Alarme para automóvel Alert 550R LCD. Alert 550R LCD 13 páginas.

Imprimir página

5. Once the engine is running, after couple seconds the parking light will turn on again

6. and climate controls will activate and adjust the vehicles interior temperature to your

7. preset setting. (While the vehicle is running, the "

LCD screen will flash and it will indicate count down timer based on the 5, 0, 0 or 0 minute

run time set up by your installation center.)

8. The vehicle will run for 5 to 0 minute cycle and automatically shut down. (When the unit

shuts off the count down timer will turn off and the transmitter will play a melody.)

Activate remote Start

Engine running

Note: The Remote Start Unit will not start the vehicle if any one of the following conditions exists:

. The hood is opened.

. The brake pedal is pressed.

. Move the optional remote start enable toggle switch to OFF position. (If installed)

4. The gear selector is in any gear other then " PARK" or " NEUTRAL"

5. Pull down the hand brake. (for Standard Transmission Gear Vehicle)

SAFE START (Child safety mode)

✱

Factory defaults setting to press the

button twice on the transmitter to start the vehicle.

Programming this feature to eliminate an accidental remote start. It requires the user presses the

✱

transmitter and

buttons at the same time to start the vehicle.

B. ENGINE START MEMORIZING FOR THE VEHICLE WITH STANDARD

(MANUAL)

TrANSmISSION gEAr (Cut the VIOLET LOOP WIRE for Standard transmission gear vehicle)

" icon and the " minutes" digit on the

The system senses the neutral transmission gear position automatically and there is no prior set-

up required. The system in the standard transmission vehicle operates as following process when

you exit the vehicle to sense and memorize the neutral transmission gear position. If the vehicles

are of automatic transmission gear, this process is omitted.

. While engine is running by ignition key, pull up the hand brake and place the transmission

gear in the neutral position.

. Before turning off the engine, press the

-- The LED indicator will flash times to confirm enter.

. Pull off the " Ignition Key" from the key cylinder.

-- Engine continues running until the pre-programmed time elapsed or shutdown input is

received.--

4. Exit from the vehicle and Close all doors.

-- The engine still continues running and it is normal operating process.--

5. Within minute from the time of step , press the button on the transmitter to lock the

doors.

6-. If the engine shuts down immediately and the system is now ready for next remote (or

programmable) engine starts.

6-. If the engine not shuts down immediately, the system is failed in engine start memorize set

up, repeat above process again.

If the door is opened after above process, the prior memorization for the next remote or pro-

grammed engine start sequence is delete and the function shall not work until you repeat above

process again.

Note: If the engine start memorize is set up, the dome light convenience delay function will be

temporarily By-pass.

C. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE

START:

To operate the vehicle while engine running on the remote start.

. Insert the ignition key and turn it to " ON" (not the start) position.

✱

button twice on the transmitter.