Atlas fan company ALESSANDRA-LK Manual de instruções - Página 11
Procurar online ou descarregar pdf Manual de instruções para Ventilador Atlas fan company ALESSANDRA-LK. Atlas fan company ALESSANDRA-LK 15 páginas. 42", 56" & 72" ceiling fan
Imprimir página
11. PROGRAMMING YOUR
FAN AND OPERATING
THE REMOTE CONTROL
Before programming takes place, fan must be
fully assembled and mounted to the ceiling with
blades attached. You must also choose which
control you will be using for programming the
fan, the remote or the wall control. No other wall
control should be used with this fan but that
whichwas included. Using another wall control
other than ours will damage your fan and void
your warranty.
SETTING UP THE TRANSMITTER
NOTE: The remote has been pre-paired in the factory
for your convenience.
1. Remove the battery cover by pressing firmly on the
arrow and sliding the cover off.
2. Install two 1.5V AAA batteries (included). Replace
the battery cover on the remote control.
LEARNING PROCESS
IMPORTANT: If you have two or more fans, please
follow steps below to control each fan independently.
Also follow steps below to re-pair the remote and the
receiver when needed.
1. Ensure AC power to the fan is OFF to begin the
learning process.
2. Turn the fan's AC power ON.
3. Within 30 seconds of turning AC power on, press
and release the "LEARN" button located in the
remote's battery compartment to enter the learning
function. The down light of your fan, if applicable, will
blink, and the fan blades will start to spin.
The fan will now accept commands from the added
remote.
NOTE: If the self calibration test failed, turn the AC
power off; restore power and process the self
calibration test again.
NOTE: During self calibration test, the remote and
the wall control are non-functional.
Battery
9
Figure 17
Figure 18