DSC Power Series Manual de instalação - Página 6

Procurar online ou descarregar pdf Manual de instalação para Unidade de controlo DSC Power Series. DSC Power Series 14 páginas. Neo image sensor
Também para DSC Power Series: Manual de referência (2 páginas), Manual (18 páginas), Manual de referência rápida (2 páginas), Instruções de instalação (2 páginas), Manual rápido (4 páginas), Manual de instruções de instalação (11 páginas)

yellow after the memory check (solid red LED).

A network reset will only work if the Image Sensor is not actively communicating with a network. If the Image

Sensor is within range of the original panel, it is required that the Image Sensor first be deleted from the panel it

was previously learned into before being able to perform a network reset on the Image Sensor. See instructions on

how to properly delete the Image Sensor from the panel. After releasing the reset button, the Image Sensor will

enter sensor power-up mode (blinking red LED) followed by memory check (solid red LED) followed by either a

blinking green or blinking yellow light. See Camera LED Reference Chart for the full list of status indicators and

expected behaviors.

PIR ACTIVATION & TEST MODE

By default, the image sensor LED does not illuminate when activated by motion unless the sensor is in test mode. The

LED can be enabled by tampering the device or on the panel for each Image Sensor on a customer's account. The

Image Sensor must have successfully completed the enrollment process with a panel. When enabled, the red LED

illuminates for 3 seconds upon motion activations (at most every 3 minutes while disarmed).

At the panel, scroll to "Image Sensor Settings" in the "Image Sensor Setup" menu. Enter "Image Sensor Settings" and

scroll to the sensor to test, press [*] Scroll to "Test PIR," press [*]. The screen will display "I.S. [y] In Test For Next 3

Min." to indicate the test mode command has been sent. (Note: It may take up to 30 seconds for test mode to take effect

after requesting "Test PIR" at the panel.)

TAMPER & TROUBLE CONDITIONS

Tamper: A built-in accelerometer detects movement or re-positioning of the Image Sensor and will initiate a tamper

whenever a change in sensor orientation is detected. The tamper automatically clears after the sensor is returned to the

upright position and no movement has been detected for 5 minutes. A tamper can also be cleared by resetting the

sensor.

Trouble Conditions: By default, trouble conditions (malfunction, tamper & low battery) are displayed on the panel LCD.

Enable or disable trouble condition messages on the control panel LCD via the Alarm.com Dealer Website. Trouble

conditions are always reported to the Alarm.com Customer Website and customers will receive tamper/low/malfunction

notifications if they are subscribed, regardless of the panel setting.

SERVICE PLANS REQUIREMENTS

Image capture features require a service plan that includes one of the following Image Sensor add-ons:

Images - Alarms- Includes upload of images from alarm events only.

Images - Plus- Includes upload of images from alarm events and non-alarm events

https://answers.alarm.com/Installation_and_Troubleshooting/Image_Sensor/DSC_PowerSeries_Neo_Image_Sensor/DSC_PowerSeries_

Updated: Tue, 17 Apr 2018 13:46:31 GMT