Aolait AL350RX Manual do utilizador - Página 8

Procurar online ou descarregar pdf Manual do utilizador para Equipamento de iluminação Aolait AL350RX. Aolait AL350RX 17 páginas.

AC power

Warning! Read "Safety Information" starting on page 5 before connecting this light to AC

mains power.

Warning! For protection from electric shock, this light must be grounded (earthed). The

power distribution circuit must be equipped with a fuse or circuit breaker and ground-

fault (earth-fault) protection.

Warning! Socket outlets or external power switches used to supply this light with power

must be located near the fixture and easily accessible so that the fixtures can easily be

disconnected from power.

Important! Do not insert or remove live Neutrik PowerCon connectors to apply or cut

power, as this may cause arcing at the terminals and damage the connectors.

Important! Do not use an external dimming system to supply power to the 350BSW as this

may cause damage to the fixture that is not covered by the product warranty.

Power voltage

Warning! Check that the voltage range specified on the fixture's serial number label matches the

local AC mains power voltage before applying power to the fixture.

This light fixtures accept AC mains power at 100-240 V nominal, 50/60 Hz. Do not apply AC

mains power to the fixture at any other voltage than that specified on the fixture's serial number

label.

A DMX 512 data link is required in order to control a 350BSW via DMX.

This light has 5-pin XLR connectors for DMX data input and output. The pin-out on all

connectors is pin 1 = shield, pin 2 = cold (-), and pin 3 = hot (+). Pins 4 and 5 in the 5-pin XLR

connectors are not used in this light but are available for possible additional data signals as

required by the DMX512-A standard.

Standard pin-out is pin 4 = data 2 cold (-) and pin 5 = data 2 hot (+).

The number of fixtures is either limited to 256 or limited by the number of DMX channels required by

the fixtures in relation to the maximum 512 channels available in one DMX universe, whichever limit is

lower. Note that if independent control of a fixture is required, it must have its own DMX channels.

Fixtures that are required to behave identically can share the same DMX channels.

To add more fixtures or groups