3W 110i R2 Manual - Página 11

Procurar online ou descarregar pdf Manual para Motor 3W 110i R2. 3W 110i R2 20 páginas.

Another method that can be used for break in would be to set the engine between 2000-2500 rpm

and let it run for 4 hours. After that the engine would basically be broken in. Note: For break-in a

smaller propeller is recommended.

Important:

Remember that when the engine running ever

person must stay behind the line of the rotating propeller; never to the side or the front!

After Initial Break In

•

Use high grade fully synthetic 2-stroke oil

•

Use the oil manufacturer's recommended gas to oil mixture

•

We use 3W 2-stroke oil in our engines here in Germany, but there are other high grade

2-stroke oils that will perform well.

Note: The engine needs 12-20 hours running time for the break in process to be 100% complete.

Additional installation notes

•

There must be a minimum 4" separation between anything attached to the receiver and

all things related to the ignition (i.e., the ignition itself, and its wires, battery, and switch)

•

Use a plastic spiral sheath to protect the ignition cables

•

Never remove the sparkplug cap by using a mechanical aid like pliers. Only remove the

cap by hand using a twist/pull movement.

•

The spark plug cap must be firmly seated to the sparkplug. If the spark plug cap is not firmly

seated there is a very good possibility that you will experience radio interference.

110i R2 / 110i R2 CS Engine Manual