Apogee Atomizer 05054 Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para Brinquedo Apogee Atomizer 05054. Apogee Atomizer 05054 8 páginas.

11. Using wood glue, attach the fins to the rocket

along the lines drawn previously. The aft edges of the

fins should be even with the aft edge of the body tube.

For straighter flights, check to make sure the fins are

perpendicular to the tube. Allow the glue some time to

dry.

12. Using wood glue, attach the two launch lugs to the

body tube on the rectangles etched onto the surface.

Double check to make sure the two small tubes are

straight. You can carefully thread a launch rod through

them to make sure they are aligned.

13. Apply a bead of wood glue to both sides of each

fin-body tube joint and each launch lug where it

attaches to the tube. Pull your finger along the joint

to smooth out and remove the excess glue. Lay the

tubes horizontally while the glue dries.

14. Tie the free end of the yellow shock cord to the

loop on the base of the shoulder of the nose cone. Put

a little wood glue on the knot to make it permanent.

15. Cut out the parachute from the plastic sheet using

scissors or a hobby knife.

16. Place one reinforcement ring on each of the

corners of the plastic parachute canopy. Take a sharp

pencil or knife and poke a hole through the plastic in

the center of each ring.

Page 4

Step 11

Step 12

Step 13

Step 14

Step 15

Step 16

Yes