Apogee Instruments SE-100 Manual do Proprietário - Página 18

Procurar online ou descarregar pdf Manual do Proprietário para Sensores de segurança Apogee Instruments SE-100. Apogee Instruments SE-100 18 páginas. Photometric sensor

Imprimir página

How To Return An Item

1. Please do not send any products back to Apogee Instruments until you have received a Return Merchandise

Authorization (RMA) number from our technical support department by submitting an online RMA form at

www.apogeeinstruments.com/tech-support-recalibration-repairs/. We will use your RMA number for tracking of the

service item. Call (435) 245-8012 or email [email protected] with questions.

2. For warranty evaluations, send all RMA sensors and meters back in the following condition: Clean the sensor's exterior

and cord. Do not modify the sensors or wires, including splicing, cutting wire leads, etc. If a connector has been attached

to the cable end, please include the mating connector – otherwise the sensor connector will be removed in order to

complete the repair/recalibration. Note: When sending back sensors for routine calibration that have Apogee's standard

stainless-steel connectors, you only need to send the sensor with the 30 cm section of cable and one-half of the

connector. We have mating connectors at our factory that can be used for calibrating the sensor.

3. Please write the RMA number on the outside of the shipping container.

4. Return the item with freight pre-paid and fully insured to our factory address shown below. We are not responsible for

any costs associated with the transportation of products across international borders.

Apogee Instruments, Inc.

721 West 1800 North Logan, UT

84321, USA

5. Upon receipt, Apogee Instruments will determine the cause of failure. If the product is found to be defective in terms

of operation to the published specifications due to a failure of product materials or craftsmanship, Apogee Instruments

will repair or replace the items free of charge. If it is determined that your product is not covered under warranty, you

will be informed and given an estimated repair/replacement cost.

PRODUCTS BEYOND THE WARRANTY PERIOD

For issues with sensors beyond the warranty period, please contact Apogee at

[email protected]

discuss repair or replacement options.

OTHER TERMS

The available remedy of defects under this warranty is for the repair or replacement of the original product, and Apogee

Instruments is not responsible for any direct, indirect, incidental, or consequential damages, including but not limited to

loss of income, loss of revenue, loss of profit, loss of data, loss of wages, loss of time, loss of sales, accruement of debts

or expenses, injury to personal property, or injury to any person or any other type of damage or loss.

This limited warranty and any disputes arising out of or in connection with this limited warranty ("Disputes") shall be

governed by the laws of the State of Utah, USA, excluding conflicts of law principles and excluding the Convention for the

International Sale of Goods. The courts located in the State of Utah, USA, shall have exclusive jurisdiction over any

Disputes.

This limited warranty gives you specific legal rights, and you may also have other rights, which vary from state to state

and jurisdiction to jurisdiction, and which shall not be affected by this limited warranty. This warranty extends only to

you and cannot by transferred or assigned. If any provision of this limited warranty is unlawful, void, or unenforceable,

that provision shall be deemed severable and shall not affect any remaining provisions. In case of any inconsistency

between the English and other versions of this limited warranty, the English version shall prevail.

This warranty cannot be changed, assumed, or amended by any other person or agreement

APOGEE INSTRUMENTS, INC. | 721 WEST 1800 NORTH, LOGAN, UTAH 84321, USA

TEL: (435) 792-4700 | FAX: (435) 787-8268 | WEB: APOGEEINSTRUMENTS.COM