Apollo XPA-CB-11170-APO Manual de instalação - Página 2

Procurar online ou descarregar pdf Manual de instalação para Sensores de segurança Apollo XPA-CB-11170-APO. Apollo XPA-CB-11170-APO 2 páginas. Diversity loop interface module
Também para Apollo XPA-CB-11170-APO: Manual de colocação em funcionamento (14 páginas), Manual de colocação em funcionamento (19 páginas)

Apollo XPA-CB-11170-APO Manual de instalação
Locking Mechanism
The detectors can be locked into the base by removing a tab as shown in Fig. 2.
To unlock the detector, insert a 1.5mm hex driver or similar diameter tool into the small hole
opposite the XPERT card and twist the detector anti-clockwise.
The XPander base module can be locked to the mounting plate by means of a grub screw.
Access to which is through the base module cover label opposite the XPERT card
The address of the unit is set using the XPERT card, see table overleaf. Commission the
detector according to the XPander commissioning guide PP2286.
Battery Type
Panasonic
6 x AA 1.5V Alkaline Panasonic Powerline (Size M, LR6)
When replacing batteries, allow the device to power down for a period of two minutes
before installing replacements.
Note: When replacement batteries are required all batteries must be replaced together.
Technical Data
Operating voltage
2.8-5VDC
Operating temperature
–10°C to +50°C
© Apollo Fire Detectors Limited 2007 TP
Fig 1 Mounting Details
Varta
6 x AA 1.5V Alkaline Varta Industrial (4006, LR6)
Snip along marked lines and remove this
part to lock the detector to the base.
© Apollo Fire Detectors Limited 2008/TP
Fig 2. Locking Mechanism
2
XPERT Card Addressing
The XPander XPERT card is specifi cally designed for XPander products and has profi led
address pips for ease of installation. The use of standard XPERT cards is not recommended.
Select the desired address and remove the pips indicated in black. Remove pips with a
small screwdriver.
XPERT Card Insertion and Removal
Removal requires access to the inner section of the base. Detach the detector from its
base. Insert a fl at-blade screwdriver just inside the rim of the base above the XPERT card
and disengage the card retaining clip whilst pulling the XPERT card out.
3