Abusemark naze32 Manual - Página 6

Procurar online ou descarregar pdf Manual para Controlador Abusemark naze32. Abusemark naze32 8 páginas. Flight controller

Mini FunFly Flight Controller "Naze32" (なぜ)

Camera Stabilization and Gimbal Mode

Naze32 can be used as a standalone camera gimbal stabilization unit. By setting multirotor

type to "Standalone Gimbal Stabilization", servo outputs 1 and 2 can drive camera gimbal

servos. Both analog (50Hz refresh) and digital (200Hz+ refresh) servos are supported.

Servo gain (amount of servo travel for given angle of tilt) is conﬁgurable for both pitch

and roll axis.

In addition to standalone stabilization, camera outputs can also be enabled when used as

a standard multirotor controller. In case of regular (PWM) receiver, this limits to Quad mixer.

In case of CPPM receiver, up to Octo can be supported while still allowing for camera control.

Channels AUX3/AUX4 can be assigned to tilt/roll the camera mount in addition to stabilization.

Servo 1

Pitch Axis

WARNING

If using high-current-draw servos for camera stabilization, consider powering

them from a separate BEC. Only connect Signal and GND wire to the board, and 5V wire

from servos to a separate power source.

Servo 2

Roll Axis

Servo

Mode