Appliance AGH 7000 Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Aquecedor Appliance AGH 7000. Appliance AGH 7000 12 páginas.

Imprimir página

Please the heater lying on the ground on a soft rug (as showed in fig. 1), remove two of the wing nuts,

pull out the extension panel, let the screw holes of bottom panel consist with the screw holes of

extension panel, then fix the winged nuts according to primary installing way (as showed Fig.2).

Figure 1

Before connecting the low-pressure regulator, please check and read the following: The gas heater

should only be powered by

15kg. Connect the low-pressure regulator with a fixed calibration of maximum 30 mbar that complies

with EN 12864:2002. The hose should be marked according to national standards and should have a

length between 50cm and 60cm. For correct connection, the hose should be connected using metal

bands of a suitable size. It needs to be replaced by the date stamped on it. For correct connection,

follow the instructions provided with the low-pressure regulator.

Slide the two metal rings around the hose. Connect the hose to the hose union of the low-pressure

regulator and to that of the tab. Close the metal rings firmly with a screw, but make sure that you do not

damage the fitting or any component.

Before connecting the low-pressure regulator to the gas container, make sure that the gas container is

closed and that there are no open flames (i.e. a lit oven) in the place where you are working. Connect

the low-pressure regulator according to the user instructions that are provided with the low-pressure

regulator.

Check for gas leaks: see section F

Place the gas container in its compartment. Take care that the hose is not twisted or obstructed, and

that it is unable to touch any hot parts of the heater;

Hook the rear cylinder cover onto the compartment by inserting the two hooks into the respective holes

of the cabinet (Fig. 3);

In addition

To replace the gas container, make sure that the gas container is closed (follow the user instructions

provided with the low-pressure regulator). Let the gas heater cool down first and make sure that there

are no open flames or other sources of heat in the area in which you are working;

10.

In addition it is recommended that the gasket seals of the regulator and the flexible rubber hose is

checked to ascertain their condition. If you have any doubt concerning the condition of the hose or the

seals, replace them;

11.

Make sure that you do not damage the connection or any other components;

12.

Never turn the gas container upside down in order to make full use of the contents. This may release

liquid residues left in the container that damage the heater irreparably;

13.

For disconnection or connection of the low-pressure regulator, always follow the user instructions

provided with the regulator;

14.

The manufacturer is not responsible for any harm or damage if attention is not paid to the points

described above.

Figure 2

iquefied

etroleum

Figure 3

as (LPG) in a container with a maximum weight of