Dusty Strings Dusty Harp Pickup Series Instruções de instalação - Página 2

Procurar online ou descarregar pdf Instruções de instalação para Instrumento musical Dusty Strings Dusty Harp Pickup Series. Dusty Strings Dusty Harp Pickup Series 5 páginas. For lever harps

Imprimir página

Remove the rubber end cap.

Turn the thumb screw on the stop collar counterclockwise to loosen. Slide

the stop collar off of the leg.

Remove the rubber O-ring from the leg.

Loosen the locking knob on the base of the harp and remove the leg.

Step 2: Drill Jack Hole

Note: Don't want to drill a hole in your harp? Dusty Strings offers a

no-drill solution for mounting your pickup jack to your harp. The Dusty

Pickup Jack Clamp may be used to eliminate the need to drill a hole in your

harp. See more at www.dustystrings.com.

Owners of Ravenna models may have a hole pre-drilled in their harp. Check for an existing hole covered by a black plastic

cap near the bottom of the left quarter stave (the angled panel to the left of the back of the harp). If you have a pre-drilled

hole, remove the cap and skip to Step 3 – Mark Pickup Element and Harness Clip Locations.

Find the center of the jack hole for your harp in the table below.

Ravenna 26 & Ravenna 34

FH26 & Allegro 26

Crescendo 34, FH34,

Crescendo 32 & FH32

FH36S, FH36H & FH36B

Using an awl, mark the position of the center of the hole on the back of the harp.

Place a folded paper towel inside the harp to collect dust and wood chips from

the drilling.

Caution: When drilling, use gentle pressure to avoid chipping out the back of the hole

and to prevent the drill from plunging through and damaging the soundboard.

Carefully drill a hole with a ½

keep the drill bit perpendicular to the surface of the harp.

Note: Using a brad-point drill bit is important. This type of bit centers

the hole and holds the bit in place, helping to prevent damage caused

by the drill bit sliding on the surface of the harp. It can also help to

ensure that the hole doesn't get "wowed out" as you drill. If needed, ½"

brad-point bits are available from Dusty Strings.

After drilling, make sure the inside edge of the hole is free of splinters.

Left Quarter Stave, 1½" up from base and centered on the

panel left to right

Center of back, 1⅛" below bottom sound hole

Center of back, 4" below bottom sound hole

Center of back, 5" below bottom sound hole

" brad-point drill bit (see figure 3). Be sure to

Figure 2 – Ravenna Drop-Down Leg

End cap

O-ring

Locking

knob

1½"

Brad-point

Standard

drill bit

Figure 3 – Drill bits

Stop

collar

1⅛"