Dusty Strings P20 Manual - Página 4
Procurar online ou descarregar pdf Manual para Amplificador de instrumentos musicais Dusty Strings P20. Dusty Strings P20 6 páginas. Pickup for lever harps
4.
Carefully remove the template from inside the harp.
5.
You should now have 3 or 4 (depending on model) clearly visible pencil dots on the soundboard and corresponding
'X' marks for the harness clips on the lining.
Step 5: Attach Harness Clips
Note: Please read this section completely before attaching clips.
1.
Place a paperclip or thin coin on the soundboard under the
lowest 'X' mark on the soundboard lining to act as a spacer.
This is to prevent the harness clip from touching the sound-
board and causing unwanted vibration.
2.
Remove the paper backing from the self-adhesive patch on
one of the harness clips.
3.
Orient the angled corners away from the soundboard and use
the spacer to position the bottom edge of the clip up off the
soundboard (see figure 6).
4.
Firmly press the clip into place over the 'X' on the soundboard
lining, keeping it as square to the soundboard as possible. The clip may be wider than the lining, and this is okay.
5.
Remove the spacer.
6.
Repeat for the remaining clips.
Step 6: Attach Pickup Harness
1.
Slide the pickup harness up through the bottom sound hole, being careful to avoid dragging or bumping the jack
against the harp.
2.
Orient the harness so the pickup element lead wires point toward the string rib, away from the side of the harp
figure 7 on next page).
3.
Slide the rubber grommets on the harness so that they align with the clips while allowing the pickup elements to line
up with the marks on the soundboard.
4.
Press the rubber grommets into the clips. The groove in each grommet should snap into place in the arms of the clip.
It is not necessary to twist the clips' "ears" together.
5.
If your particular installation leaves you with an extra grommet (this will be the case with the FH36S), you can
either leave it alone, or you can very carefully cut it off with a sharp blade, diagonal cutter, or scissors.
Soundboard
Figure 6 – Spacers
(See next page)
4
Soundboard
lining
Spacers
(see