ADE GW400-15 Manual de instruções - Página 10
Procurar online ou descarregar pdf Manual de instruções para Balanças ADE GW400-15. ADE GW400-15 16 páginas. Electronic compact scales
Imprimir página
Replacing/inserting the battery
If the usage time is drastically reduced when the battery is fully charged, it must be replaced.
In this case, please contact your local dealer or service partner.
Make sure you remove the battery when the scale is permanently operated
from the mains supply.
If the scale will not be used for a long time, unplug the charger from the
mains supply to protect the battery.
To change or remove the battery, switch off the scale and disconnect it from the power supply.
After about a minute, open the battery compartment on the underside of the scale.
Remove the battery from the battery compartment, disconnect the connectors from the cable
lugs and replace the battery.
Installation proceeds in the reverse order.
Faults and error messages
Below you will find a list of possible errors and faults. If necessary, these can be eliminated
with simple means. If the fault or error cannot be eliminated or other error messages occur,
please contact your service partner.
Faults
Fault
The scale has switched off
automatically.
The display
shows nothing.
The scale is not connected to the
mains.
Draughts or air movements
Weight display is
Vibrations
unstable.
Electromagnetic fields / static
charging
The scale is not levelled
properly.
The weighing
The scale is not operating in the
result is
specified temperature range.
obviously wrong.
Electromagnetic fields / static
charging
Zeroing is not
Zeroing is not possible if the
possible.
displayed weight exceeds +/- 2%
of the capacity of the scale.
10
Cause
Measure
Switch on the scale.
Use the optional mains adapter to
connect the scale to the mains.
Close the window.
Choose a different location.
Avoid vibrations.
Choose a different location.
Choose a different location. If
possible, switch off the interfering
device.
Adjust the support feet. Use the
spirit level to check the horizontal
position.
Operate the scale only in the
permissible temperature ranges.
Choose a different location. If
possible, switch off the interfering
device.
In this case, switch the scale off and
on again.
GW400-210408-Rev004-UM-en