Austro Flamm WOODY Instruções para o utilizador - Página 7
Procurar online ou descarregar pdf Instruções para o utilizador para Fogão a lenha Austro Flamm WOODY. Austro Flamm WOODY 11 páginas.
Imprimir página
english
2. CORRECT OPERATION OF YOUR STOVE
Approved fuels
Dry, well cured and natural wood (hardwood).
Maximum amount of fuel
Maximum amount of fuel to be added: 1,6 kg wood. Larger
amounts of fuel can lead to overheating and thus damage the
stove.
Clean burning
The wood must be dry (relative wood moisture < 15%) and
untreated and the right amount of wood must be burned in
order to ensure a clean fire that releases only small amounts
of emissions.
Startup procedures
During the first 3-4 operations - at nominal heat output - there
may be some odour development and the paint has not yet
hardened.
Making a fire
For the correct and safe operation of your stove please pay
attention of the chimney developing the necessary feed
pressure. This must especially be considered before the
initial operation (or e.g. after the summer heating break) and
during the mid-season heating periods (e.g. at strong wind,
etc.).
If there is not enough feed pressure, please light only some
paper or small kindling first, in order to "warm up" the stove
and the chimney.
The air inlet must not be covered or closed.
Clean grate, empty ash drawer if necessary (watch out for
ambers!)!
Position the lever for the combustion air to the open ("AUF")
position (see fig.2 and 4).
Place 2-3 logs (approx. 1,2 kg in total) crossways in the
combustion chamber (1) with sufficient distance from each
other (min. 2 cm), on top of that place some softwood
chippings (approx. 0,7 kg) (2) and some ignition aid and light.
(3) (see fig. 3)
3
Figure 3:ignite the fire
7
Close the door!
We recommend to let the first load burn down without
changing the air lever position.
As soon as no visible flames are left (only embers in the
combustion chamber), you can put another load of logs
(approx. 1,6 kg) in the combustion chamber if desired. (see
fig. 5)
When reloading the stove please repeat the procedure as
mentioned under "first lighting": air lever top position (= open),
open door carefully, place logs, close door.
After a few minutes, when the logs burn well on all sides
(bright, high flames), you can adjust the heat output with the
air lever (lever on top position = maximum heat output), the
flames should be yellow and never look blueish or have black
tips (otherwise add more air) – see fig. 4. Never close air
supply completely during operation. (danger of flash-fire!)
The stove door may be opened only for refuelling or disposing
of ashes and is to be closed again afterwards.
2
1
WOODY / WOODY Xtra
Fig. 4: air knob
Figure 5