ADEMCO 5800WAVE Manual de instalação e configuração - Página 3

Procurar online ou descarregar pdf Manual de instalação e configuração para Sistema de segurança ADEMCO 5800WAVE. ADEMCO 5800WAVE 4 páginas. Wireless siren module

Imprimir página

RECEPTACLE

COVER PLATE

IN POSITION

NOTE:

FOR C-UL INSTALLATIONS THE

MOUNTING SCREW IS NOT USED.

Figure 5. Final Installation

Regular maintenance and inspection (at least annually) by the installer and frequent testing by

the user are vital to continuous satisfactory operation of any alarm system.

The installer should assume the responsibility of developing and offering a regular maintenance

program to the user, as well as acquainting the user with the proper operation and limitations

of the alarm system and its component parts. Recommendations must be included for a specific

program of frequent testing (at least weekly) to insure the system's operation at all times.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following

statement for your information:

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance

with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found

to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are

designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• If using an indoor antenna, have a quality outdoor antenna installed.

• Reorient the receiving antenna until interference is reduced or eliminated.

• Move the radio or television receiver away from the receiver/control.

• Move the antenna leads away from any wire runs to the receiver/control.

• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user

or installer may find the following booklet prepared by the Federal Communications Commission helpful:

This booklet is available under Stock No. 004-000-00450-7 from the U.S. Government Printing Office, Washington, DC 20402.

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's

Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.

SPECIFICATIONS

Dimensions:

7.5" W x 4.5" H x 2.25" D.

191mm W x 114mm H x 57mm D.

Input Voltage:

120VAC

Current:

205mA. Typical

Range:

200ft (60m) nominal indoors (the actual range to be

determined with the security system in the TEST mode).

Operational Temperature:

32° to 122° Fahrenheit.

MOUNTING

Siren Output Level:

SCREW

95dB at 3 feet

TO THE INSTALLER

FCC ID: CFS8DL5840

"Interference Handbook"

LISTED