ADEMCO TI110B1 Manual do utilizador - Página 14

Procurar online ou descarregar pdf Manual do utilizador para Sistema de segurança ADEMCO TI110B1. ADEMCO TI110B1 18 páginas. Gsm/pstn dual network burglar alarm system

Imprimir página

Meantime, the zones will be replaced by the Characters " Disarm" and "Emergency Zone" on

the LCD display.

(3) Arm/Disarm by remote-site cell phone

Dialing the telephone connected to the alarm panel by remote-site telephone, and you will hear

indicator voice. Several rings later, you input the 4-digit password. If the password is correct, you

will hear a long prompt voice and then you can continue to input "2" to arm the alarm panel or

input "8" to disarm the alarm panel; if the password is wrong, you also can hear a short indicator

voice to remind that you can continue to input the correct one without hanging up the telephone.

17. Dispose the alarm by fixed telephone

When alarming, the alarm panel will dial the alarm receiving numbers in order and circulately.

And you can hear the alarm language segments first (20 seconds), and later the alarm host will

listen-in the locale. And during the listening-in time, the alarm whistle will pause and you are

allowed to dial "7777" to disarm the host. When the alarm panel dials the first group of number,

you hang it off immediately or don't disarm the host, and the host will continue to next one in

order and circulately till the host is disarmed. (Note: every number will be dialed three times). And

if you want the alarm panel to dial this group of telephone, you can input "0000" and the host will

not dial this number.

18. Emergency Alarm

The Zone 7 is the default to be the emergency zone, and it is the 24-hour zone without controlled

by the disarm/arm operation. Any press the

(Emergency Zone). When some unexpected events happen, you can press the

trigger alarm whistle. And the LCD displays "Emergency" with the indicator glittering. (Note: the

indicator will not glitter until you disarm the alarm panel)

Ⅴ.Installation:

1. Install the Wireless Magnetic

Contact

（1）Make sure that the door (window) frame

where the magnetic contact is to be

installed are enough clean before

installation. And when installation,

please

take

off

adhesive tape coating at their bottom,

and then install the transmitter on the

fixed door(window) frame while the magnetic panel is installed on the mobile

door(window).

（2）The two "

"on the transmitter and the magnetic panel should aim at each other

and the distance between them should be within 1cm（see diagram1）

（3）To make sure that you have a successful installation, please open the door for test. The

on the remote control will trigger the Zone 7

Magnetic

Panel

the

double-faced

Diagram 1:Wireless Magnetic door detector

button to

Indicator lamp

Red lamp is on

when transmitting

Green lamp is on

while under-voltage

Transmitter

Less than1cm