dB Technologies B-HYPE MOBILE Manual do utilizador - Página 13

Procurar online ou descarregar pdf Manual do utilizador para Altifalantes dB Technologies B-HYPE MOBILE. dB Technologies B-HYPE MOBILE 18 páginas. Bi-amp battery-powered speaker

Imprimir página
In particular cases and when necessary, it is possible to
To do this you need to purchase a new transmitter and a
new receiver, both operating in the new band.
The 3 bands shown in the previous page could not be
all available, depending on the Country of sale (refer to
your authorised dealer).
!
WARNING
The operation must be carried out with
product turned off and disconnected
from the power mains. It must be
carrie o t
in order to prevent any electrostatic
discharge (ESD) that could damage the
product.
The procedure requires to replace the receiver
installed on B-HYPE MOBILE and then proceed with
the synchronisation with a new radio microphone that
works in the new selected band.
To replace the R-BHM receiver:
•
With device off, disconnect any audio and power
supply wiring.
•
Loosen the 2 screws of R-BHM
•
Partially remove the receiver and disconnect the
three mini-connectors shown:
C1 - 3-pin connector (power supply-audio)
C2 - 2-pin connector (antenna A)
C3 - 2-pin connector (antenna B)
•
Bring the new R-BHM operating in the new band
closer
•
Connect C1, C2, C3
•
Completely insert R-BHM
•
Tighten the 2 screws of R-BHM
For full functionality, synchronise the transmitter/
receiver as shown in the relevant paragraph.
B-HYPE MOBILE
34

CHANGE OF FREQUENCY BAND

alifie per onnel
English
Code 420120272 REV. 1.2