Autonics BM Series Manual de início rápido - Página 5
Procurar online ou descarregar pdf Manual de início rápido para Acessórios Autonics BM Series. Autonics BM Series 5 páginas.
Imprimir página
Amplifier Built-in Type for General Purpose
Retroreflective type
1. Supply the power to the photoelectric sensor, after
setting the photoelectric sensor and the reflector (MS-2)
or reflective tape face to face.
2. Set the photoelectric sensor in the position which
indicator turns on, by adjusting the reflector, reflective
tape or the sensor right and left, up and down.
3. Fix both units tightly after checking that the unit detects
the target.
※ If using more than 2 photoelectric sensors in parallel,
the space among them should be more than 30cm.
Photoelectric
sensor
※If reflectance of target is higher than non-glossy white
paper, it might cause malfunction by reflection from the
target when the target is near to photoelectric sensor.
Therefore put enough space between the target and the
photoelectric sensor or the surface of the target should
be installed at angle of 30° to 45° against optical axis.
30° to 45°
※ If the mounting place is too narrow,
please use MS-5 instead of MS-2.
※ Please use reflective tape (MST
series) for where a reflector is not
installed.
Reflectivity by Reflective Tape
Model
MST-50-10 (50×50mm)
70%
MST-100-5 (100×100mm)
110%
MST-200-2 (200×200mm)
170%
※This reflectivity is based on the reflector (MS-2).
※ Reflectivity may vary depending on usage environment
and installation conditions.
The sensing distance and minimum sensing target size
increase as the size of the tape increases.
Please check the reflectivity before using reflective
tapes.
※ For using reflective tape, installation distance should be
min. 20mm.
Reflector (MS-2)
Adjust
Right/Left
Reflective tape
(MST Series)
Adjust Up/Down
L
Reflector (MS-2)
Sensing
Reflective tape
target
(MST Series)
<MS-5>
SENSORS
CONTROLLERS
MOTION DEVICES
SOFTWARE
(A)
Photoelectric
Sensors
(B)
Fiber Optic
Sensors
(C)
LiDAR
(D)
Door/Area
Sensors
(E)
Vision
Sensors
(F)
Proximity
Sensors
(G)
Pressure
Sensors
(H)
Rotary
Encoders
(I)
Connectors/
Connector Cables/
Sensor Distribution
Boxes/ Sockets
A-73