Autopilot APCETHD Manual - Página 3

Procurar online ou descarregar pdf Manual para Controlador Autopilot APCETHD. Autopilot APCETHD 18 páginas.

Page 2

APCETHD

Installation

Secure the unit to a wall.

Determine the best location for the remote probe. Place the probe

in an area with good air movement preferably at plant height.

Avoid placing the probe in direct sunlight or under direct HID

Lighting.

NOTE: Do not place the sensor probe where it will

come in to contact with water. The unit is not

waterproof!

The remote probe has a quick disconnect to easily remove or

connect the probe. Secure the quick disconnect to the unit by

securing the QD screw to the unit.

Plug the power cable into a standard NEMA 5-15 wall outlet. A

120 volt power supply is required.

Ensure that all of the devices being connected to the controller

have the proper voltage and will not exceed the maximum

amperage rating of this unit.

Note: Now is the time to customize your settings prior

to connecting any equipment.

The sensitivity of the photocell may be adjusted.

Press both Enter/Reset and Up buttons and hold for 3 seconds.

The current photocell setting will be displayed. Press Up to

increase the number displayed and the sensitivity. (requires less

light to activate photocell) Press Down to decrease the number

and the sensitivity (requires more light to activate photocell).

Press Enter / Reset to accept the change.