Autopilot APCG8NG Manual - Página 11

Procurar online ou descarregar pdf Manual para Inversor Autopilot APCG8NG. Autopilot APCG8NG 13 páginas. 4 burner co2 generator (lp or ng)

Page 10

APCG4

Q & A

The grow area is getting too humid or hot? Remove the left

burner and replace with the supplied pipe plug. This will

reduce heat and humidity.

Should the APCG4 be buzzing and / or sparking? Yes,

when the unit is firing you will hear "sparking" sounds. It will

attempt this up to 5 times, before going into lock out mode.

However it is not usual for the unit not to start after 5 times

unless the gas flow has been interrupted.

The indicator light beside the "Lock Out (error)" is

flashing. The unit may be out of propane or the gas supply

may have been interrupted. The safety mode or Lock Out

(error) is an automatic built-in feature that will activate if the

pilot does not fire after 5 attempts. Once the problem has been

corrected, turning the power off for 30 seconds and back on

will reset this function. It will also reset after 20 minutes and

attempt to ignite the burners.

How should the flame(s) appear? The flames should burn

clean and blue with a resemblance to a flower or 6 point star.

If the flame is yellow, extra large or a small blue dot not

resembling a flower or 6 point star, DO NOT OPERATE THE

GENERATOR... consult the factory

Does it matter which burner I remove? Yes, the burner on

the right located directly under the igniter must remain in

place.

How much CO2 does the unit produce? The brass burners

are designed to produce approximately 3 cu ft per hr. If more

CO2 production is required, select a CO2 generator with more

burners.