Autopilot APCG8NG Manual - Página 7

Procurar online ou descarregar pdf Manual para Inversor Autopilot APCG8NG. Autopilot APCG8NG 13 páginas. 4 burner co2 generator (lp or ng)

Page 6

APCG4

Start Up Procedure (cont)

The unit should fire before 5 attempts however, after 5

unsuccessful attempts, the module will lock itself out and the

LED light next to "Lock Out (error)" will be illuminated. Turn off

the unit and wait 5 minutes to allow the gas to dissipate. Retry

to start the generator.

NOTE: If starting the unit for the first time or after a

new tank is connected, make sure to "purge" the gas

line of any air to ensure gas is flowing to the

burners.

Once the burners ignite, look under the unit and confirm the

flame is blue and consistent and resembles a flower or 6 point

star.

!!WARNING!! Power the unit off immediately if the flame

appears yellow or excessively large. DO NOT OPERATE

with yellow, excessively large, or small "lazy" blue flames.

If the flame appears yellow or too large, verify the correct gas

supply is being used and that the supplied gas regulator is

being used. High pressure or incorrect gas type may increase

flames to dangerous heights.

If the flame is blue but appears small, verify the correct gas

supply is being used (if LP, verify tank level is not low) and

that the supplied gas regulator is being used. Low pressure or

low LP tank may cause small or "lazy" blue flames.

After the generator has been tested at full capacity, connect

the APCG4 to a compatible controller or timer.

!!WARNING!! The APCG4 produces up to almost 11,000

BTU's of heat at full capacity. Verify the area around the

APCG4 is not getting too hot for the surroundings.